Dating site Posts

The dunkirk boiler dating assured, what false

Posted in Dating

The Wall. Click here to Find a Contractor in your area. Here are the website rules, as well as some tips for using this forum. If you've found help here, check back in to let us know how everything worked out. It's a great way to thank those who helped you. Need to contact us? Steve Whitbeck Member Posts:

I then took the top off to clean it. Surprise - You can't get a wire and nylon bristle brush between the nipples. The factory was NO help.

They first talked to me like I was an idiot. Then they suggested using a garden hose on it. Come on people this is in someones basement and the nearest floor drain is 6 ft away.

Lennox/Dunkirk boiler

What have you guys used to clean one of these. For a gas boiler to soot up like that something must be way wrong. Is it is set up for natural or propane? Pressures ok? Enough combustion air?

Has anyone had problems with Dunkirk Boilers?

Water leak in boiler when burner firing? Concerned Sooting is not typically associated with gas boilers, and when it is, it is a serious matter.

with you

Oil can produce soot well before there is a threat of Carbon Monoxide CO production, on the contrary, soot and CO go hand in hand when dealing with gas. The problem is most likely the use of well gas. I am not aware of any boiler that is approved for use with anything other than propane of natural gas.

seems brilliant

There is no way of telling the purity and potency of well gas, both of which can contribute to a sooting condition. Cleaning the boiler may be the immediate concern, but my overall concern is for the safety of the homeowners. If the reason for the sooting can not be determined and fixed, I would suggest the boiler not be placed back in operation. To clean a boiler that is plugged with soot can prove to be a challenge. It is very important to make sure the boiler is totally clean, this is probably why washing it with water was suggested.

Any soot left behind will act as a restriction, creating a potential for reoccurance. There are of course brushes made to clean boilers. Your local heating wholesaler may stock them. If this is the chosen method, I would still recommend spraying a mist of water in the boiler, fire it up, and let the moisture bake off the remaining soot repeat as necessary.

And have faced

If the boiler is not totally clean, I again have to recommend it not be placed in operation. I am sorry that your experience with our factory personel was anything other than totally enjoyable.

Dunkirk boiler dating - Men looking for a man - Women looking for a woman. Find single man in the US with mutual relations. Looking for love in all the wrong places? Now, try the right place. Find a woman in my area! Free to join to find a man and meet a . 85 Middle Rd, Dunkirk, NY marionfoaleyarn.com Recalls (Empty) Trademarks & Service Marks (Disclaimer) Any of the trademarks, service marks, collective marks, design rights or similar rights that are mentioned, used or cited in the articles of the Building Intelligence Center (marionfoaleyarn.com) are the. Exclusive Dealer Site! Dunkirk Installer Today! Smarter & More Efficient! New Floor Standing Models! Since , Dunkirk has delivered innovative, efficient, and dependable home heating products to professionals, building owners, and homeowners. We take pride in our products and listen to the people in the field who are doing the hard work.

If you have any concerns, please feel free to contact me atext. Steamhead Member Posts: 13, This is the kind of factory response and support we like to see. Nice going, Pete. I don't think the subject of well gas has come up on the Wall before. I'm guessing that the HO has a well on the property and gets the gas for free. Since this is very appealing in an era of skyrocketing energy costs, I would expect it to come up again.

Maybe the company operating the well could test the gas for purity, BTU content etc and so inform Tinkerer and the HO?

Quick Links

The only time I've seen gas boilers sooted up is when the burners are overfired, air shutters are closed too far or the chimney is restricted. Tinkerer, I'm sure you've checked all these things as far as possible- this installation probably doesn't have a meter to clock and we don't know the exact BTU content anyway.

Nov 08, Hello, I'm having an issue with my Dunkirk gas boiler. It will not heat. The circulator pump is working, the pilot light is on, the power is on, but no heat is being produced in the house. The air/gas pressure is where it should be. I'm completely stumped. Everything worked great yesterday. Woke up this morning with no heat!5/5(K). 75 - - - - - - MBH. #N#D Series Commercial Boiler. Settle down francis. The question was- Has anyone had problems with Dunkirk Boilers? Absolutely! Nothing but problems with Dunkirk for the last 5 years. I am thankful to see this thread so I know that I am not marionfoaleyarn.com've had problems for 5 long years. The first 2 years it was replaced 2 times. Maybe three, I can't recall anymore. I'm over it.

Let us know what you come up with! All Steamed Up, Inc.

something and excellent

Sooting One othe thing that can cause sooting of a gas boiler is debris from construction such as dry wall dust or sawdust. Please make sure that the boiler is covered during those messy times. Short cycling can also cause sooting I recently had a boiler in which the previous servicer installed too small of a transformer.

assured, what error

The boiler would spark, light the pilot, then signal for low fire and then high. When the current draw of the high fire hit the trans, voltage would drop causing the pilot valve to close.

This just kept repeating itself until the call for heat was removed. Another soot up was when a boiler was leaking and rusted up the burner ports near the pilot light. The pilot would light and then gas built up in the combustion chamber and popped, blowing out the pilot. Again this just kept happening until the call for heat ended.

Find the cause. On the first another company cleaned the boiler a few hours before I arrived and replaced all the burned up controls, but not the transformer, so it was still shortcycling. He also did the classic Peter Desins. This boiler is 9 months old and yes it is on well gas. I have worked with boilers on well gas for many years.

The problem is that the gas pressure can sometimes drop below normal operating range and this can cause the boiler to soot up.

Dunkirk Boiler Reviews Consumer Ratings - Dunkirk offers several hot water boilers from wall mounted boilers to cast iron boilers and they even have a boiler for light commercial applications. Wall mounted boilers are typically condensing boilers that off high efficiency and do not take up much floor space as they are wall mounted.

Click the Circle Above Over 4, visitors per year - - and growwwwing! Recommended Inspection Resources:. Help Spread The Word!

Dunkirk boiler dating

Grrrr, leave it to some kajillion dollar corporation to make more work for me. No date code used in serial number. Call and provide serial number. They will have info of initial buyer and date of purchase.

It's "H.

consider, what very

Smith are part of a group in Westfield, MA called "Mestek". On a side note, I saw a brand-new Weil-McLain oil-fired hydronic boiler with a cracked section the other day. Never assume anything as usual.

I always use an extension mirror and get on my knees to check the visible underside areas of cast iron sectional boilers for leaks. I'll try to post the photo of the cracked boiler section. You can post now and register later. If you have an account, sign in now to post with your account. Paste as plain text instead. Only 75 emoji are allowed. Display as a link instead. Clear editor. Upload or insert images from URL. By Mike Lamb Started March 5. By Robert Jones Started February 1, By Jerry Simon Started April Reply to this topic Start new topic.

think, that

Recommended Posts. Report post. Posted April 19, Dave Tontarski. Share this post Link to post Share on other sites. Hi Dave, Dunkirk uses the first four digits of the serial number, and it's the week followed by the year, so that one was manufactured the 50th week of Thanks Mike. Hi All, A couple of months ago, after I put together that serial number decoder for water heaters, a few of you asked for something like that for boilers. Utica is, well, I guess, manufactured in Utica, NY.

Their products are always blue.

Nov 12, I just purchsed a new home 6 mo ago. I am running into some siding problems. I have hardiplank and some of it is falling off around the bottom of the house. I went to repair it and found out the problem is that the nails were shot into it . The Building Intelligence Center recommends annual inspections and service be performed by a qualified inspector or service technician/contractor. The age of your furnace, air conditioner, water heater, or boiler can play an important part of this maintenance, and assist property owners with decisions to either repair or replace with more. Cleaning a DUNKIRK boiler I have a customer that I installed a new Dunkirk boiler 80%er. It is on well gas and he must have had a pressure drop because it sooted up. I then took the top off to clean it. Surprise - You can't get a wire and nylon bristle brush between the nipples. The factory was NO help. They first talked to me like I was an idiot.

Slant Fin.



Facebook twitter google_plus reddit linkedin
Kazragrel

Fenrile

3 Comments

  1. Araran
    Zolora

    You are absolutely right.

    03.02.2020
    |Reply
  2. Kazuru
    Turg

    Very amusing idea

    07.02.2020
    |Reply
  3. Tausar
    Molabar

    I am assured, what is it error.

    02.02.2020
    |Reply

Leave a Reply

Your email address will not be published. Required fields are marked *